Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 07-530 — Xerox WorkCentre 3550

Code: 07-530

Description: Jam 0 From the Bypass Tray
Causes: The registration sensor failed to actuate within the correct time after paper was fed from the bypass tray.
Remedy: 1. Switch off the machine, then switch on the machine. 2. Open the front cover assembly . Remove all jammed paper. 3. Check the paper path for damage or obstructions. 4. Check that the bypass pickup roll assembly is clean. If necessary, install a new bypass pickup roll assembly . 5. Check the bypass tray retard pad. If necessary, install a new retard pad . 6. Check that the registration sensor actuator moves freely and is not damaged. If necessary, install a new registration sensor actuator . 7. Enter dC330 code 08-500. Check the registration sensor (Q08-500). If necessary, install a new HVPS . NOTE: The registration sensor is mounted on the HVPS. 8. Enter dC330 code 04-100 to run the main BLDC motor. 9. Check the wiring between the main BLDC motor and CN38 on the Main PWB. 10. While the main BLDC motor runs, stack the code 08-800 to energize the bypass feed clutch (CL08-800). Check that the bypass pickup roll assembly rotates. 11. Check the wiring between the bypass feed solenoid and CN37 on the Main PWB. 12. If necessary: a. Install a new bypass feed assembly . b. Perform OF7 Main PWB Check RAP.

← Xem tất cả mã lỗi Xerox WorkCentre 3550

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie