Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 08-100 — Xerox WorkCentre 3550

Code: 08-100

Description: Jam 1
Causes: The lead edge of the document failed to actuate the fuser exit sensor within the correct time after registration.
Remedy: 1. Switch off the machine, then switch on the machine. 2. Open the front cover assembly . Remove all jammed paper. 3. Remove the print cartridge and the fuser module . Check the paper path for damage or obstructions. 4. Open the fuser door . Check the following, install new components as necessary: a. The fuser exit sensor actuator moves freely and is not damaged. b. The fuser heat roll , pressure roll 1 and pressure roll 2 are clean and rotate freely. c. The fuser exit roll and idlers are clean and rotate freely. d. The fuser stripper fingers . 5. Enter dC330 code 08-600. Check the fuser exit sensor (Q08-600). If necessary, install a new HVPS . NOTE: The fuser exit sensor is mounted on the HVPS. 6. Reinstall the fuser. Enter dC330 code 04-200. Check that the exit motor (MOT04-200) , runs and drives the fuser rolls. 7. Check the wiring between the exit motor and CN2 on the Connection PWB. Install new components as necessary . 8. Enter dC330 code 04-100 to run the main BLDC motor. 9. Check the wiring between the main BLDC motor and CN38 on the Main PWB. 10. If necessary: a. Install a new print cartridge . b. Perform OF7 Main PWB Check RAP.

← Xem tất cả mã lỗi Xerox WorkCentre 3550

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie