Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 08-600 — Xerox WorkCentre 3550

Code: 08-600

Description: Duplex Jam 0
Causes: The lead edge of the document failed to actuate the duplex jam 1 sensor within the correct time.
Remedy: 1. Open the rear cover assembly . Remove the duplex assembly , then remove all jammed paper. 2. Check the paper path for damage or obstructions. 3. Check that the duplex gate , moves freely and is not damaged. 4. Check that the duplex jam 1 sensor actuator moves freely and is not damaged. If necessary, install a new duplex jam 1 sensor actuator . 5. Enter dC330 code 08-700. Check the duplex jam 1 sensor (Q08-700). If necessary, install a new HVPS . NOTE: The duplex jam 1 sensor is mounted on the HVPS. 6. Remove the exit motor . Check the following components are clean and rotate freely: a. Exit roll . b. Exit roll idlers and . c. Transport roll . d. Transport roll idlers . Install new components as necessary and . 7. Reinstall the exit motor. Enter dC330 code 04-220 to run the exit motor in reverse. Check that the exit motor runs and drives the exit rolls . 8. Check the wiring between the exit motor and CN2 on the Connection PWB. Install new components as necessary . 9. Enter dC330 code 04-300 to run the duplex motor (MOT04-300) . Check that the duplex drive gear rotates. 10. Check the wiring between the duplex motor and CN7 on the Connection PWB. Install new components as necessary . 11. Manually rotate the duplex drive belt . Check that the duplex drive rolls are clean and rotate freely. Install new components as necessary . 12. Install new components as necessary: • Duplex assembly . • Connection PWB

← Xem tất cả mã lỗi Xerox WorkCentre 3550

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie