Code: 10-100, 10-200
Description: Open Fuser Error/Low Heat Error
Causes: 10-100 During normal operation, the temperature of the fuser has dropped below the operating level. 10-200 The fuser has failed to reach the correct operating temperature.
Remedy: 1. Switch off the machine, then switch on the machine. 2. Enter dC330 code 10-100 to heat the fuser to 180 degrees. Enter codes 10-200 to verify the condition of the thermistor. 3. Switch off the machine. Remove the fuser assembly. Check that the thermistor is clean and in good contact with the fuser heat roll. Check the wiring to the thermistors. Install new components as necessary . 4. Check for continuity between the two pins on the fuser assembly connector . NOTE: A cold fuser has a resistance of approximately 9 ohms (220V/240V) or 1.6 ohms (110V). 5. Check that there is continuity through the fuser heater and across the over temperature cut-out. 6. Check the wiring between the following connectors: a. The fuser connector and CON2 on the SMPS. b. The fuser connector and CN19 on the Main PWB. If necessary, install a new fuser connector . 7. If necessary: a. Install new components: • Fuser assembly . • SMPS . b. Perform OF7 Main PWB Check RAP.