Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 10-300 — Xerox WorkCentre 3550

Code: 10-300

Description: Over Heat Error
Causes: The fuser temperature has risen above the normal level. Although the fuser unit can return to a normal operating temperature, the fuser may consequently be damaged.
Remedy: 1. Enter code dC330 code 10-200. Perform a fuser temperature check to verify the condition of the thermistors. 2. Switch off the machine. Remove the fuser assembly. Examine the fuser assembly for heat damage. Install new components as necessary . 3. Check that the thermistor , is clean and in good contact with the fuser. Check the wiring to the thermistor. Install a new thermistor as necessary . 4. Check that there is continuity through the fuser heater and across the over temperature cut-out. If necessary, install a new thermostat assembly . 5. Check the wiring between the following connectors: a. The fuser connector and CON2 on the SMPS. b. The fuser connector and CN19 on the Main PWB. If necessary, install a new fuser connector . 6. If necessary: a. Install new components: • Fuser assembly . • SMPS . b. Perform OF7 Main PWB Check RAP.

← Xem tất cả mã lỗi Xerox WorkCentre 3550

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie