Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 20-100 ... 20-900 — Xerox WorkCentre 3550

Code: 20-100 ... 20-900

Description: Fax Faults
Causes: These are the faults displayed when the machine encounters fax problems. The faults are listed in code order, together with any recommended actions. Please note that the service actions are limited. If the machine has a fax fault without displaying a fault code, go to the 20A Fax Faults Without a Code RAP.
Remedy: 20-100 Communication Error A communication failure has occurred with either the fax transmission or reception. Resend the fax. 20-110 Mailbox Error The machine is not available for mailbox communication. Go to GP 4 System Administration Tools. Check that the mailbox ID and password are correct. 20-120 Scanning Error While sending a fax using manual dial, a scanning error has occurred. Clear any jams. Switch off the machine, then switch on the machine. Resend the fax. If the fault persists, check the scanner, refer to the 14-100 CCD Lock RAP. 20-200 Group Not Available The user has selected a group location where only a single location can be used, or when the group location is unavailable. Try again, checking for the correct group location. 20-300 Incompatible The remote party does not have the feature the user has requested, for example, polling. Change the settings, then resend the fax. 20-400 Line Busy The remote party did not answer. Wait, then resend the fax. 20-410 Line Error There is a problem with the phone line, affecting transmission or reception. Try again and if necessary, wait for the line to clear. 20-500 Memory Full The fax data memory is full. Delete any unnecessary documents awaiting transmission, or wait until more memory becomes available, or split the current Fax in to smaller units. 20-550 Low Memory The available fax memory is getting low. 20-600 No Answer It has not been possible to connect to the remote fax, even after re-dial attempts. Check that the remote fax is on line and try again. 20-700 Number Not Assigned No number has been assigned for the speed dial location selected. Assign a number to this location or dial the number manually. 20-800 Power Failure During a power-off period, the machine has lost its user memory. Check that the backup battery is holding its charge of about +3V. If necessary, install a new battery. Wait, then resend the fax. 20-900 Retry Redial This indicates that the machine is waiting to re-dial. Press Start to re-dial immediately, or press Stop to cancel the re-dial procedure. Final Actions Perform the following: 1. Install a new fax PWB : 2. Perform the OF7 Main PWB Check RAP.

← Xem tất cả mã lỗi Xerox WorkCentre 3550

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie