Code: OF1
Description: Audible Noise
Causes: Use this RAP to isolate and identify the source of unusual noises.
Remedy: 1. Ask the customer if there are any specific machine functions that are noisy. 2. Identify the source of the noise by exercising the machine in all modes. 3. Use diagnostics to run individual components. 4. Go to the relevant subsection: • Main Drives and Paper Transport • LSU • DADF • Tray 2 5. Refer to Possible Causes and Potential Solutions. Main Drives and Paper Transport • Enter dC330 code 04-100 to run the main BLDC motor. The following components will be run. – The print cartridge . – The registration roll . – The registration roll idler . • While the main BLDC motor runs, stack the code 08-810 to energize the tray 1 pickup solenoid and run the tray 1 pickup roll and feed roll . • While the main BLDC motor runs, stack the code 08-850 to energize the registration solenoid and run the registration roll and registration roll idler . • While the main BLDC motor runs, stack the code 08-800 to energize the bypass feed solenoid and run the bypass pickup roll . • Enter dC330 code 04-300 to run the duplex motor. The duplex rolls and , will rotate. • Enter dC330 code 04-200 to run the exit motor. The following fuser components will be run: – The heat roll in the fuser . – The pressure rolls in the fuser and . – Exit roll . • Enter dC330 code 04-120 to run the main fan . • Enter dC330 code 10-500 to run the fuser fan . • Enter dC330 code 09-500 to run the SMPS fan . LSU • Enter dC330 code 06-100 to run the LSU motor. DADF • Enter dC330 code 05-200 to run the scan motor , in the DADF. The following components will be run: – Scan roll . – Exit roll . • While the scan motor runs, stack the code 05-300 to energize the pickup solenoid and run the DADF pickup roll assembly . • While the DADF scan motor runs, stack the code 05-310 to energize the registration solenoid and run the registration roll . Tray 2 • Enter dC330 code 07-210 to run the tray 2 feed motor . The tray 2 feed roll , will rotate. • While the tray 2 feed motor runs, stack the code 08-820 to energise the tray 2 pickup solenoid and run the tray 2 pickup roll assembly . Possible Causes and Potential Solutions Go to the relevant procedure: • Squeaks • Unusual Noise from the Scanner Assembly Squeaks Possible causes are: • Contamination of the bushes and drive shafts. Solution: – Clean the components. – Plastic bushes should be cleaned and lubricated. – Install new components as necessary. • Bearings in cooling fans Solution: – Install new components as necessary. • Mis-adjusted or worn drive belts. Solution: – Install new components as necessary. • Mis-aligned or damaged parts. Solution: – Check for parts that are damaged or out of position. – Adjust the components if appropriate. – Install new components as necessary. • Noise from the DADH input tray document guides. Solution: – Clean the DADH input tray in the area beneath the input guides. Unusual Noise from the Scanner Assembly Possible causes are: • Mis-aligned or damaged parts. • Defective motor driver. Solution: • Check the position of the scan motor and associated gears . • Ensure the CCD module , moves freely. • Install new components as necessary .