Code: 15
Description: No image.
Causes: 1. Has the seal tape been removed? 2. Is the GND OPC well grounded? 3. LSU running well? 4. Is the bias voltage normal? 5. Low toner? 6. Is there video data from Main PBA
Remedy: 1. Remove the seal tape. 2. Measure the resistance between. frame ground and the ground spring attached to the frame. If necessary clean the components to achieve a good earth. 3. Adjust LSU or install a new LSI. 4. Normal Dev bias = -350V. 5. If necessary install a new toner cartridge. 6. Test engine test pattern, if necessary, install a new Main PBA