Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 08-100 — Xerox WorkCentre 4150

Code: 08-100

Description: Jam 1 RAP 08-100 The lead edge of the document failed to actuate the exit sensor within the correct time after registration.
Remedy: 1. Switch off the machine, then switch on the machine. 2. Open the right cover assembly, PL 7.30 Item 1. Remove all jammed paper. 3. Check the paper path for damage or obstructions. 4. Remove the fuser, PL 10.10 Item 4. Check that the exit sensor actuator, PL 10.25 Item 12 moves freely and is not damaged. If necessary, install a new exit sensor actuator, PL 10.25 Item 12. 5. Check the fuser stripper fingers, PL 10.25 Item 3. Install new components as necessary, PL 10.25. 6. Enter dC330 code 08-600. Check the exit sensor (Q08-600), PL 10.15 Item 2. 7. Check the wiring between the exit sensor and CN6 on the Main PWB. If necessary, install a new exit sensor, PL 10.15 Item 2. 8. Check that the registration sensor actuator, PL 8.15 Item 4 moves freely and is not damaged. If necessary, install a new registration sensor actuator assembly, PL 8.15 Item 13. 9. Enter dC330 code 08-500. Check the registration sensor (Q08-500), PL 8.15 Item 8. 10. Check the wiring between the registration sensor and CN13 on the Main PWB. If necessary, install a new registration sensor, PL 8.15 Item 8. 11. Enter dC330 code 10-400. Check that the fuser motor (MOT10-400), PL 10.20 Item 3, runs and drives the fuser rolls. 12. Check the wiring between the fuser motor and CN12 on the Main PWB. Install new components as necessary, PL 10.25. 13. Enter dC330 code 04-100 to run the main BLDC motor. 14. While the main BLDC motor runs, stack the code 08-850 to energize the registration clutch (CL08-850). Check that the registration roll, PL 4.15 Item 1 rotates. 15. Check the wiring between the registration clutch, PL 4.15 Item 4 and CN13 on the Main PWB. Install new components as necessary, PL 4.15. 16. Clean the registration roll, PL 4.15 Item 1 and the registration roll idler, PL 4.15 Item 7. Install new components as necessary. 17. Install new components as necessary: • Fuser, PL 10.10 Item 4. • Main PWB, PL 1.10 Item 1.

← Xem tất cả mã lỗi Xerox WorkCentre 4150

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie