Code: 12-740
Description: Ejector Fault RAP 12-740 The machine has detected a fault with the ejector.
Remedy: 1. Switch off the machine, then switch on the machine. 2. Remove all documents from the finisher. 3. Check for damage or obstructions that would prevent the ejector, PL 12.40 Item 16 from operating correctly. 4. Enter dC330 code 12-835. Check the ejector encoder sensor (Q12-835), PL 12.25 Item 3. 5. Check the wiring between the ejector encoder sensor and J13 on the Finisher PWB. If necessary, install a new ejector encoder sensor, PL 12.25 Item 3. 6. Enter dC330 code 12-830. Check the ejector home sensor (12-830), PL 12.20 Item 7. 7. Check the wiring between the ejector home sensor and J7 on the Finisher PWB. If necessary, install a new ejector home sensor, PL 12.20 Item 7. 8. Enter dC330 code 12-500. Check that the ejector motor (MOT12-500), PL 12.40 Item 1 runs and drives the ejector belt, PL 12.40 Item 7. 9. Check the wiring between the ejector motor and J6 on the Finisher PWB. 10. Check that the finisher PWB DIP switch settings are correct. Refer to the 12A Finisher PWB DIP Switch Settings RAP. 11. If necessary, install new components: • Ejector motor, PL 12.40 Item 1. • Ejector assembly, PL 12.40 Item 16. • Finisher PWB, PL 12.10 Item 8.