Code: 10-100, 10-200
Description: Open Fuser Error/Low Heat Error RAP 10-100 During normal operation, the temperature of the fuser has dropped below the operating level. 10-200 The fuser has failed to reach the correct operating temperature.
Remedy: 1. Switch off the machine, then switch on the machine. 2. Enter dC330 code 10-100 to heat the fuser to 180 degrees. Enter codes 10-200 and 10- 210 to verify the condition of the thermistors. 3. Enter code 10-300 to check power supply unit 2. If necessary, install a new power supply unit 2, PL 1.10 Item 4. 4. Switch off the machine. Remove the fuser assembly. Check that the thermistors, PL 10.25 Item 9 are clean and in good contact with the fuser heat roller. Check the wiring to the thermistors. Install new components as necessary, PL 10.25. 5. Check for continuity between the two pins on the fuser assembly connector, PL 10.25 Item 8. NOTE: A cold fuser has a resistance of approximately 11.5 ohms (220V/240V) or 2 ohms (110V). 6. Check that there is continuity through the fuser heater and across the over temperature cut-out. 7. Check the wiring between the fuser connector, PL 4.15 Item 20 and CON3, CON8 and CON9 on Power Supply Unit 2. If necessary, install a new fuser connector. 8. Check the wiring between CON4 on Power Supply Unit 2 and CN7 on the Main PWB. 9. Install new components as necessary: • Fuser assembly, PL 10.25 Item 1. • Main PWB, PL 1.10 Item 1. • HVPS, PL 1.10 Item 2.