Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 12-100 — Xerox WorkCentre 4260

Code: 12-100

Description: Finisher Jam 3 RAP 12-100 The finisher entrance sensor failed to actuate within the correct time after the document was fed from the exit sensor.
Remedy: 1. Open the finisher front door, PL 12.10 Item 1. Lower the document entry guide PL 12.15 Item 23. Remove all jammed documents. Open the right cover assembly, PL 7.30 Item 1, remove all jammed paper. 2. Check the document entry guide, PL 12.15 Item 23 for damage. 3. Check that the finisher entry sensor actuator, PL 12.15 Item 20 moves freely and is not damaged. 4. Enter dC330 code 12-800. Check the finisher entrance sensor (Q12-800), PL 12.15 Item 15. 5. Check the wiring between the finisher entrance sensor and J7 on the Finisher PWB. If necessary, install a new finisher entrance sensor, PL 12.15 Item 15. 6. Enter dC330 code 12-100. Check that the entrance motor (MOT12-100), PL 12.15 Item 5 runs and drives the finisher entry roll, PL 12.15 Item 2. 7. Check the wiring between the entrance motor and J5 on the Finisher PWB. 8. Check the drive belt, PL 12.15 Item 26. If necessary, install a new drive belt. 9. Check that the finisher entry roll, PL 12.15 Item 2 and the finisher entry roll idlers, PL 12.15 Item 21 are clean and rotate freely. 10. Check that the finisher PWB DIP switch settings are correct. Refer to the 12A Finisher PWB DIP Switch Settings RAP. 11. If necessary, install new components: • Entrance motor, PL 12.15 Item 5. • Finisher PWB, PL 12.10 Item 8.

← Xem tất cả mã lỗi Xerox WorkCentre 4260

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie