Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 12-200 — Xerox WorkCentre 4260

Code: 12-200

Description: Finisher Jam 4 RAP 12-200 The exit sensor failed to actuate within the correct time after the document was fed from the finisher entrance sensor.
Remedy: 1. Open the finisher front door, PL 12.10 Item 1. Lower the document entry guide PL 12.15 Item 23. Remove all jammed documents. 2. Check that the exit sensor actuator, PL 12.20 Item 3 moves freely and is not damaged. NOTE: If necessary, remove the finisher to check the exit sensor actuator. Refer to REP 12.1. 3. Enter dC330 code 12-805. Check the exit sensor (Q12-805), PL 12.20 Item 7. 4. Check the wiring between the exit sensor and J7 on the Finisher PWB. If necessary, install a new exit sensor, PL 12.20 Item 7. 5. Enter dC330 code 12-100. Check that the entrance motor (MOT12-100), PL 12.15 Item 5 runs and drives the transport roll, PL 12.15 Item 2. 6. Check the wiring between the entrance motor and J5 on the Finisher PWB. 7. Check the drive belt, PL 12.15 Item 26. If necessary, install a new drive belt. 8. Check that the transport roll, PL 12.15 Item 2 and transport roll idlers, PL 12.15 Item 21 are clean and rotate freely. 9. Check that the finisher PWB DIP switch settings are correct. Refer to the 12A Finisher PWB DIP Switch Settings RAP. 10. If necessary, install new components: • Document entrance motor, PL 12.15 Item 5. • Finisher PWB, PL 12.10 Item 8.

← Xem tất cả mã lỗi Xerox WorkCentre 4260

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie