Description: Fusing Unit On Time Fail Any of the following was detected: • The Heater Rod did not turn OFF within the specified time after the Heater Rod On. • After power ON, the temperature of the Fusing Unit does not reach the specified value within the specified time.
Remedy: Check the following: • The Heater Rod for operation failure. • The connection between the LVPS J511 and the Fusing Unit P10 for open circuit and poor contact • The Center Thermistor for dropped parts, sensor contamination, and foreign substances blocking the sensor. • The Heat Roll for wound up, stuck paper. If no problem is found, replace the following parts in sequence: • Fusing Unit (PL 7.1) • LVPS (PL 18.1) • ESS/MCU PWB (PL 18.1)