Description: Tray 1/Tray 2/MSI No Paper Any of the following was detected: • The paper in the applicable Tray has ran out. (When the APS function of Tray 1 and Tray 2 is disabled) • Although the paper in the applicable Tray was detected to have ran out, paper is not supplied from another Tray. (When the APS function of Tray 1 and Tray 2 is enabled)
Remedy: 1. Load paper into the applicable Tray. (If this had occurred during APS of Tray 1 or Tray 2, load paper with the same settings as for the aplicable Tray into other than MSI.) 2. If the problem persists, check the following: • The paper supply mechanism of the applicable Tray for damage and foreign substances. • The No Paper Sensor of the applicable Tray (Input Check [072-100/101/102]) for operation failure. (PL 9.1, PL 10.3, PL 13.3) • The No Paper Sensor of the applicable Tray for contamination, improper installation, and Actuator operation failure. 3. If no problem is found, replace the following parts: • ESS/MCU PWB (Tray 1/MSI) (PL 18.1) • STM PWB (Tray 2) (PL 10.6)