Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi E1-2 — Xerox WorkCentre 5020

Code: E1-2

Description: Exit SNR on JAM. Timeout between IOT Registration Clutch ON and Fuser Exit Sensor ON.
Remedy: I/O Diagnostic Codes • [08-10] IOT Registration Clutch • [10-23] Fuser Exit Sensor
Check Items: • Registration Roll dirty, contaminated with paper dust, worn, or faulty • Fuser Exit Sensor dirty and Sensor Actuator deformed or damaged • Paper damaged or not within specification • Foreign matter, burrs, or paper in the paper path • Drive gear worn or damaged • IOT Registration Clutch faulty • Check that the IOT Registration Clutch and the LVPS J503-4/5 ( P/J503) pins are connected securely with good electrical contact. If there is no problem, replace the IOT Registration Clutch (PL 2.9). • Check that the following wires are connected securely with good electrical contact. If there is no problem, replace the Fuser Exit Sensor (PL 6.2). – Wire between Fuser Exit Sensor J153-3 ( P/J153) and LVPS J505-1 ( P/J505) – Wire between Fuser Exit Sensor J153-2 and LVPS J505-2 – Wire between Fuser Exit Sensor J153-1 and LVPS J505-3 • Replace the AIOC PWB (PL 8.1) .

← Xem tất cả mã lỗi Xerox WorkCentre 5020

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie