Code: 062-380
Description: AGC Failure BSD-Reference: CH 6.2. Control logic has detected insufficient light from the Illumination Lamp during AGC (Automatic Gain Congrol) of the auto IIT Calibration at Start.
Remedy: Check for any obstructions in the optical path. Clean the Mirror, lens and the white balance strip. Switch off the power then switch it on again. The problem has been resolved. Y↓N→Enter the Diagnostic Mode. Enter Component Control Code [62-02]. The lamp is good. Y↓N→Check that the Lamp harness is properly connected and repair if necessary. Replace the Illumination Lamp. Replace the SLCC PWB and (3) EEPROMS (AIOC/Network PWB). (PL 8.1) POPO the machine and retry.