Description: Tray 3 Unknown Paper Size One of the following errors was detected. • During Copy Job and Diag Job, Tray 3 was selected but the paper guides in Tray 3 are in a configuration that is not supported by the System. • During Copy Job and Diag Job, Tray 3 was selected but it has been pulled out.
Remedy: Press [Stop] on the UI Panel and either install Tray 3 or check the position of the paper guides and load the correct paper. NOTE: When performing the operation again, the same Fault will occur if the user had proceeded without changing the settings. If the problem persists, check the following: • The Tray 3 paper guide mechanism for damage and foreign substances. • The Tray 3 Paper Size Switch for damage, improper installation, and Actuator operation failure. • Tray 3 Paper Size Switch: Analog Monitor [072-052]/Input Check [072-110] (PL 11.1) • The connection between the Tray 3 Paper Size Switch J820 and the 2TM PWB J548 for open circuit, short circuit, and poor contact. If no problems are found, replace the following parts in sequence: • 2TM PWB (PL 11.6) • ESS/MCU PWB (PL 18.3)