Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 024-949 — Xerox WorkCentre 5024

Code: 024-949

Description: Tray 4 Unknown Paper Size One of the following errors was detected. • During Copy Job and Diag Job, Tray 4 was selected but the paper guides in Tray 4 are in a configuration that is not supported by the System. • During Copy Job and Diag Job, Tray 4 was selected but it has been pulled out.
Remedy: Press [Stop] on the UI Panel and either install Tray 4 or check the position of the paper guides and load the correct paper. NOTE: When performing the operation again, the same Fault will occur if the user had proceeded without changing the settings. If the problem persists, check the following: • The Tray 4 paper guide mechanism for damage and foreign substances. • The Tray 4 Paper Size Switch for damage, improper installation, and Actuator operation failure. • Tray 4 Paper Size Switch: Analog Monitor [072-053]/Input Check [072-113] (PL 11.1) • The connection between the Tray 4 Paper Size Switch J824 and the 2TM PWB J548 for open circuit, short circuit, and poor contact. If no problems are found, replace the following parts in sequence: • 2TM PWB (PL 11.6) • ESS/MCU PWB (PL 18.3)

← Xem tất cả mã lỗi Xerox WorkCentre 5024

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie