Description: Tray 2 No Paper Any of the following was detected: • The paper in the Tray 2 has ran out. (When the ATS function of Tray 2 is disabled) • Although the paper in the Tray 2 was detected to have ran out, paper is not supplied from another Tray. (When the ATS function of Tray 2 is enabled)
Remedy: 1. Load paper into the Tray 2. (If this had occurred during ATS of Tray 1 or Tray 2, load paper with the same settings as for the applicable Tray into other than MSI.) 2. If the problem persists, check the following: • The paper supply mechanism of the applicable Tray for damage and foreign substances. • The No Paper Sensor of the Tray 2 (Input Check [072-101]) for operation failure. (PL 10.3) • The No Paper Sensor of the Tray 2 for contamination, improper installation, and Actuator operation failure. 3. If no problem is found, replace the following parts: • ESS/MCU PWB (PL 18.3) • STM PWB (Tray 2) (PL 10.6)