Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 077-106 — Xerox WorkCentre 5024

Code: 077-106

Description: Fusing Unit Exit Sensor On Jam The Fusing Unit Exit Sensor did not turn ON within the specified time after the Regi Clutch On.
Remedy: Check the following: • The Fusing Unit Exit Sensor (Input Check [071-106]) for operation failure. (PL 7.1) • The Main Drive Motor (Output Check [042-001]) for operation failure. (PL 3.1) • The Regi Clutch (Output Check [071-001]) for operation failure. (PL 15.1) • The Fusing Unit Exit Chute for improper installation and deformation. • The Transfer Unit for a decrease in the transportation force. • The Drive Gear for wear and damage. • The Heat Roll for wound up, stuck paper. • A paper transportation failure due to foreign substances on the paper path. • Usage of out of spec paper. • Check that the width of the lead edge of the fed paper is more than 190 mm (the distance between 2 fingers of the ERU). • If the width of the fed paper is equal to or less than 190 mm and the jam occurs continuously, add the Finger Assy (019K 12750) to the center of the ERU. If no problems are found, replace the ESS/MCU PWB (PL 18.3).

← Xem tất cả mã lỗi Xerox WorkCentre 5024

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie