Description: Finisher Set Eject JAM RAP After the Eject Motor turned On, the Compile No Paper Sensor did not turn Off within the specified time.
Remedy: Execute Component Control[012-151 Compile No Paper Sensor]. Actuate the Compile No Paper Sensor with paper. The display changes. Y↓N→Check the connections of J8880 and J8984. J8880 and J8984 are connected correctly. Y↓N→Connect J8880 and J8984. Check the wire between J8880 and J8984 for an open circuit or a short circuit. The wire between J8880 and J8984 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Measure the voltage between the Finisher PWB P8984-3 (+) and GND (-). The voltage is approx. +5VDC. Y↓N→Replace the Finisher PWB (PL 23.16). Measure the voltage between the Finisher PWB P8984-2 (+) and GND (-). Actuate the Compile Paper Sensor with paper. The voltage changes. Y↓N→Replace the Compile Paper Sensor (PL 23.12). Replace the Finisher PWB (PL 23.16). Alternately execute Component Control[012-054 Eject Motor FORWARD LO] and Component Control[012-055 Eject Motor FORWARD HI]. The Eject Motor starts up. Y↓N→Check the connections of P/J8878 and P/J8983. P/J8878 and P/J8983 are connected correctly. Y↓N→Connect P/J8878 and P/J8983. Check the wire between J8878 and J8983 for an open circuit or a short circuit. The wire between J8878 and J8983 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Measure the resistance of the Eject Motor between each point of J8878-1/3/4/6. The resistance is approx. 2Ohm. Y↓N→Replace the Eject Motor (PL 23.11). Measure the voltage between the Finisher PWB (PL 23.16) J8983-5/6/7/8 (+) and GND (- ), and between P8846-12 (+) and GND (-). The voltage is approx. +24VDC. Y↓N→Replace the Finisher PWB (PL 23.16). Replace the Eject Motor (PL 23.11). If the problem persists, replace the Finisher PWB (PL 23.16). Replace the Finisher PWB (PL 23.16).