Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 012-259 — Xerox WorkCentre 5230

Code: 012-259

Description: Eject Home Sensor ON Failure RAP - Eject Motor operated in reverse motion with Eject Clamp Home Sensor OFF; this sensor not detected to turn on subsequently within designated time period - Eject Motor operated in reverse motion with Eject Clamp Home Sensor OFF; this sensor not detected to be on upon stop after being detected to be on.
Remedy: Y N Replace the parts that are interfering with operation. Execute Component Control[012-250 Eject Clamp Home Sensor]. Actuate the Eject Clamp Home Sensor with paper. The display changes. Y↓N→Check the connections of J8870 and P/J8988. J8870 and P/J8988 are connected correctly. Y↓N→Connect J8870 and P/J8988. Check the wire between J8870 and J8988 for an open circuit or a short circuit. The wire between J8870 and J8988 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Measure the voltage between the Finisher PWB P8988-9 (+) and GND (-). The voltage is approx. +5VDC. Y↓N→Replace the Finisher PWB (PL 23.16). Measure the voltage between the Finisher PWB P8988-8 (+) and GND (-). Actuate the Eject Clamp Home Sensor with paper. The voltage changes. Y↓N→Replace the Eject Clamp Home Sensor (PL 23.11). Replace the Finisher PWB (PL 23.16). Alternately execute Component Control[012-054 Eject Motor FWD LO] and Component Control[ 012-055 Eject Motor FWD HI]. The Eject Motor (PL 22.9) starts up. Y↓N→Check the connections of P/J8878 and P/J8983. P/J8878 and P/J8983 are connected correctly. Y↓N→Connect P/J8878 and P/J8983. Check the wire between J8878 and J8983 for an open circuit or a short circuit. The wire between J8878 and J8983 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Measure the resistance of the Eject Motor (PL 22.9) between each point of J8878-1/3/4/6. The resistance is approx. 2Ohm. Y↓N→Replace the Eject Motor (PL 22.9). Measure the voltage between the Finisher PWB (PL 23.16) P8983-5/6/7/8 (+) and GND (- ). The voltage is approx. +24VDC. Y↓N→Replace the Finisher PWB (PL 23.16). Replace the Eject Motor (PL 22.9). If the problem persists, replace the Finisher PWB (PL 23.16). Replace the Finisher PWB (PL 23.16).

← Xem tất cả mã lỗi Xerox WorkCentre 5230

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie