Description: Rear Tamper Failure RAP After the Rear Tamper started moving to the home position, the Rear Tamper Home Sensor did not turn On within 800ms.
Remedy: Manually operate the Tamper mechanism. The Tamper mechanism moves smoothly. Y↓N→Replace the parts that are interfering with operation. Execute Component Control[012-221 Rear Tamper Home Sensor]. Actuate the Rear Tamper Home Sensor with paper. The display changes. Y↓N→Check the connections of J8882 and J8984. J8882 and J8984 are connected correctly. Y↓N→Connect J8882 and J8984. Check the wire between J8882 and J8984 for an open circuit or a short circuit and GND (-). The voltage is approx. +5VDC. Y↓N→Replace the Finisher PWB (PL 23.16). Measure the voltage between the Finisher PWB P8984-8 (+) and GND (-). Actuate the Rear Tamper Home Sensor with paper. The voltage changes. Y↓N→Replace the Rear Tamper Home Sensor (PL 23.12). Replace the Finisher PWB (PL 23.16). Alternately execute Component Control[012-026 Rear Tamper Motor FRONT ON] and Component Control[012-029 Rear Tamper Motor REAR ON]. The Rear Tamper Motor starts up. Y↓N→Check the connections of P/J8883 and J8984. P/J8883 and J8984 are connected correctly. Y↓N→Connect P/J8883 and J8984. Check the wire between J8883 and J8984 for an open circuit or a short circuit. The wire between J8883 and J8984 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Measure the resistance of the Front Tamper Motor between J8984-19 and each point of J8984-1/3/4/6. The resistance is approx. 750Ohm. Y↓N→Replace the Front Tamper Motor (PL 23.12). Measure the voltage between the Finisher PWB J8984-19 and each point of J8984-1/3/4/ 6. The voltage is approx. +24VDC. Y↓N→Replace the Finisher PWB (PL 23.16). Replace the Front Tamper Motor (PL 23.12). If the problem persists, replace the Finisher PWB (PL 23.16). Replace the Finisher PWB (PL 23.16).