Code: 024-976
Description: Finisher Staple Status Failed RAP • After the Stapler Motor turned On (Forward rotation), the system did not detect that the Staple Head Home Sensor switched from Off to On within the specified time. • After the Stapler Motor turned On (Reverse rotation), the Staple Head Home Sensor did not turn On within the specified time.
Remedy: Alternately execute Component Control[012-046 Staple Motor FORWARD ON] and Component Control[012-047 Staple Motor REVERSE ON]. The Stapler Motor can be heard. Y↓N→Check the connections of J8887 and P/J8981. J8887 and P/J8981 are connected correctly. Y↓N→Connect J8887 and P/J8981. Check the wire between J8887 and J8981 for an open circuit or a short circuit. The wire between J8887 and J8981 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Replace the Staple Assembly (PL 23.8). If the problem persists, replace the Finisher PWB (PL 23.16). Execute Component Control[012-244 Staple Head Home Sensor]. Alternately execute Component Control[012-046 Staple Motor FORWARD ON] and Component Control[012-047 Staple Motor REVERSE ON]. The display changes. Y↓N→Check the connections of P/J8896 and P/J8981. P/J8896 and P/J8981 are connected correctly. Y↓N→Connect P/J8896 and P/J8981. Check the wire between J8886 and J8981 for an open circuit or a short circuit. The wire between J8886 and J8981 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Measure the voltage between the Finisher PWB P8852-1 (+) and GND (-). The voltage is approx. +5VDC. Y↓N→Replace the Finisher PWB (PL 23.16). Replace the Staple Assembly (PL 23.8). If the problem persists, replace the Finisher PWB (PL 23.16). Replace the Finisher PWB (PL 23.16). If the problem persists, replace the MCU PWB (PL 9.1).