Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 075-135 — Xerox WorkCentre 5230

Code: 075-135

Description: MPT Registration Sensor On JAM RAP After the MPT Feed Solenoid turned On, the Registration Sensor did not turn On within the specified time.
Remedy: Check the guide. The guide is set correctly. Y↓N→Set the guide correctly. Check the installation of the MPT. The MPT is installed correctly. Y↓N→Install the MPT correctly. Check for foreign substances, distortion and paper powder in the paper transport path. No distortion, foreign substances, or paper powder are found in the paper transport path. Y↓N→Clear away the foreign substances and paper powder. Correct the distortion. Execute Component Control [089-100 Registration Sensor]. Manually activate the actuator of the Registration Sensor (PL 2.4). The display changes. Y↓N→Check the connection of P/J104. P/J104 is connected correctly. Y↓N→Connect P/J104. Check the wire between J104 and J403 for an open circuit or a short circuit. The wire between J104 and J403 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Measure the voltage between the MCU PWB P403B-13 (+) and GND (-). The voltage is approx. +5VDC. Y↓N→Replace the MCU PWB (PL 9.1). Measure the voltage between the MCU PWB P403B-8 (+) and GND (-). Actuate the Registration Sensor with paper. The voltage changes. Y↓N→Replace the Registration Sensor (PL 2.4). Replace the MCU PWB (PL 9.1). Execute Component Control [071-036 Main Motor ON]. The Main Motor in the Main Drive Assembly starts rotating and the Fuser starts up. Go to the OF 3 (MAIN DRIVE ASSY RAP). Execute Component Control [071-012 MPT Feed Solenoid ON]. The MPT Feed Solenoid (PL 7.2) can be heard. Y↓N→Check the connections of P/J205 and P/J411. P/J205 and P/J411 are connected correctly. Y↓N→Connect P/J205 and P/J411. Measure the resistance of the MPT Feed Solenoid (PL 7.2). (Between P205-1 and P205-2). The resistance is approx. 90Ohm. Y↓N→Replace the MPT Feed Solenoid (PL 7.2). Check the wire between P205 and J411 for an open circuit or a short circuit. The wire between P205 and J411 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Replace the MCU PWB (PL 9.1). Replace the MCU PWB (PL 9.1).

← Xem tất cả mã lỗi Xerox WorkCentre 5230

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie