Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 077-129 — Xerox WorkCentre 5230

Code: 077-129

Description: Registration Sensor On JAM (Duplex Feed/Stop Case) RAP In the case where Duplex feeding stops, the Registration Sensor did not turn On within the specified time after the Duplex Motor turned On.
Remedy: Check the installation of the DUP Module. The DUP Module is installed correctly. Y↓N→Install the DUP Module correctly. Check the Transport Roll for wear and paper powder. The Transport Roll is ok. Y↓N→Replace the Transport Roll. Check for foreign substances, distortion and paper powder in the paper transport path. No distortion, foreign substances, or paper powder are found in the paper transport path. Y↓N→Clear away the foreign substances and paper powder. Correct the distortion. Execute Component Control [089-100 Registration Sensor]. Manually activate the actuator of the Registration Sensor (PL 2.4). The display changes. Y↓N→Check the connection of P/J104 and P/J403. P/J104 and P/J403 are connected correctly. Y↓N→Connect P/J104 and P/J403. Check the wire between J104 and J403 for an open circuit or a short circuit. The wire between J104 and J403 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Measure the voltage between the MCU PWB P403B-13 (+) and GND (-). The voltage is approx. +5VDC. Y↓N→Replace the MCU PWB (PL 9.1). Measure the voltage between the MCU PWB P403B-8 (+) and GND (-). Actuate the Registration Sensor with paper. The voltage changes. Y↓N→Replace the Registration Sensor (PL 2.4). Replace the MCU PWB (PL 9.1). Execute Component Control [073-016 Duplex Motor ON]. The Duplex Motor (PL 8.1) can be heard. Y↓N→Check the wire between P/J212 and P/J542 for an open circuit or a short circuit. The wire between J212 and J542 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Replace the Duplex Motor (PL 8.1). If the problem persists, replace the Duplex PWB (PL 8.1). Replace the Duplex PWB (PL 8.1).

← Xem tất cả mã lỗi Xerox WorkCentre 5230

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie