Description: HCF to Feed Out Sensor Fault RAP The Tray 2 Feed Out Sensor did not come on within the specified time after the start of feed from Tray 6 (HCF).
Remedy: Execute Component Control [071-100 Tray Feed Out Sensor]. Move the actuator of the Tray 2 Feed Out Sensor manually or with paper. The display changes. Y↓N→Go to 8.2 BSD and check the following wires for an open wire, short or poor contact: • Tray Feed Out Sensor P/J105-2 to MCU PWB P/J410-14 • Tray Feed Out Sensor P/J105-1 to Tray Module PWB P/J410-15 • Tray Feed Out Sensor P/J105-3 to Tray Module PWB P/J410-13 If OK, replace the Tray Feed Out Sensor (PL 2.5) before replacing the MCU PWB (PL 9.1). Execute Component Control [077-003 Takeaway Clutch]. There is operation noise from the Takeaway Clutch 1. Y↓N→Go to 8.2 BSD and check the Takeaway Clutch for an open. Check the following: • Takeaway Rolls 1 and 2 and 3 for dirt/paper particles/wear/a poor rotation • HCF and IOT for a poor docking • HCF Transport Belt for poor tension • HCF Transport Roll for dirt/paper particles/wear/a poor rotation • HCF Takeaway Rolls 1-3 for dirt/ paper particles/wear/a poor rotation • HCF Exit Roll for dirt/ paper particles/wear/a poor rotation • Drive gears for wear/breakage • If the results of the above checks are OK, replace Tray Module PWB (PL 13.8) and the MCU PWB (PL 9.1) one at a time in the order shown.