Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 078-102 — Xerox WorkCentre 5230

Code: 078-102

Description: HCF to Registration Sensor Fault RAP The paper transported from HCF did not turn on the Registration Sensor within the specified time.
Remedy: Execute Component Control [089-100 Reg. Sensor]. Place paper in front of the Reg. Sensor. The display changes. Y↓N→Go to 8.7 BSD and check the following for an open wire, short or poor contact: • Reg Sensor P/J104-2 to MCU PWB P/J403-B8 • Reg Sensor P/J104-1 to MCU PWB P/J403-B13 • Reg Sensor P/J104-3 to MCU PWB P/J403-B3 If OK, replace the Reg. Sensor (PL 2.4) before replacing the MCU PWB (PL 9.1). Execute Component Control [078-007 Tray 6 Takeaway Motor]. There is operation noise from the Tray 6 Takeaway Motor. Y↓N→Check the wire-wound resistance of Pre Reg. Motor is approx. 0.8 ohms at the measurement points below. • JF57-3 to pins 1/2 • JF57-4 to pins 5/6 If OK, go to 8.9 BSD and troubleshoot the Tray 6 Takeaway Motor circuit. Check the following: • Takeaway Rolls 1 and 2 and 3 for dirt/paper particles/wear/a poor rotation • Pre Reg Roll for dirt/paper particles/wear/a poor rotation • Drive gears for wear/breakage • Drawer Connectors and contact points for foreign objects/bent pins/burnout • If the results of the above checks are OK, replace Tray Module PWB (PL 13.8) and the MCU PWB (PL 9.1) one at a time in the order shown

← Xem tất cả mã lỗi Xerox WorkCentre 5230

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie