Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 078-104 — Xerox WorkCentre 5230

Code: 078-104

Description: HCF Feed Out Sensor Fault RAP The paper transported from HCF did not turn on the Feed Out Sensor within the specified time.
Remedy: Execute Component Control [078-101 Tray 6 Feed out Sensor]. Place paper in front of the Feed Out Sensor. The display changes. Y↓N→Go to 8.9 BSD and check the following for an open wire, short or poor contact: • Feed Out Sensor PF67-2 to HCF PWB PF01-2 • Feed Out Sensor PF67-1 to HCF PWB JF01-3 • Feed Out Sensor PF67-3 to HCF PWB JF01-1 If OK, replace the Feed Out Sensor (PL 18.7) before replacing the HCF PWB (PL 18.8). Execute Component Control [078-007 Tray 6 Takeaway Motor]. There is operation noise from the Tray 6 Takeaway Motor. Y↓N→Check the wire-wound resistance of Tray 6 Takeaway Motor is approx. 0.8 ohms at the measurement points below. • JF57-3 to pins 1/2 • JF57-4 to pins 5/6 If OK, go to 8.9 BSD and troubleshoot the Tray 6 Takeaway Motor circuit. Check the HCF paper lift components and repair as required (PL 18.2, PL 18.3).

← Xem tất cả mã lỗi Xerox WorkCentre 5230

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie