Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 078-900 — Xerox WorkCentre 5230

Code: 078-900

Description: HCF Feed Out Sensor Static Jam RAP The tray 6 Feed Out Sensor static jam.
Remedy: Execute Component Control [078-101 Tray 6 Feed Out Sensor]. Move the actuator of the Tray 6 Feed Out Sensor. The display changes. Y↓N→Go to 8.8 BSD and check the following for an open wire, short or poor contact: • Tray 6 Feed Out Sensor PF67-2 to HCF PWB PF01-2 • Tray 6 Feed Out Sensor PF67-1 to HCF PWB PF01-3 • Tray 6 Feed Out Sensor PF67-3 to HCF PWB PF01-1 If OK, replace the Tray 6 Feed Out Sensor (PL 18.7) then the HCF PWB (PL 18.8). Execute Component Control [078-007 Tray 6 Takeaway Motor: 640mm/s]. There is operation noise from the Tray 6 Takeaway Motor. Y↓N→Check the wire-wound resistance of Pre Reg. Motor is approx. 0.8 ohms at the measurement points below. • JF57-3 to pins 1/2 • JF57-4 to pins 5/6 If OK, go to 7.14 BSD and troubleshoot the Tray 6 Takeaway Motor circuit. Execute Component Control [089-002 REgistration Clutch. Registration Clutch operates Y↓N→Go to 8.7 BSD and check the Registration Clutch for an open. Check the following: • Drive gears for wear/breakage • HCF and IOT for a poor docking • HCF Transport Belt for poor tension • HCF Transport Roll for dirt/paper particles/wear/a poor rotation • HCF Takeaway Rolls 1-3 for dirt/ paper particles/wear/a poor rotation • HCF Exit Roll for dirt/ paper particles/wear/a poor rotation • If the results of the above checks are OK, replace HCF PWB (PL1.8).

← Xem tất cả mã lỗi Xerox WorkCentre 5230

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie