Description: HCF Paper Misfeed RAP There is a problem with one of the following: • HCF Lift, Lift Motor • HCF Feed Motor
Remedy: Enter Component Control [078-003 or 004 Tray 6 Feed/Lift Motor ON]. The Tray 6 Feed/Lift Motor (PL 18.4) can be heard (the lifted paper plate drops when the tray is opened). Y↓N→Check the connections of JF57 and JF06. JF57 and JF06 are connected correctly. Y↓N→Connect JF57 and JF06. Check the wire-wound resistance of Tray 6 Takeaway Motor is approx. 0.8 ohms at the measurement points below. • JF57-3 to pins 1/2 • JF57-4 to pins 5/6 If OK, go to 8.9 BSD and troubleshoot the Tray 6 Takeaway Motor circuit. Execute Component Control [078-101 Tray 6 Feed Out Sensor]. Move the actuator of the Tray 6 Feed Out Sensor. The display changes. Y↓N→Go to 8.9 BSD and check the following for an open wire, short or poor contact: • Tray 6 Feed Out Sensor PF67-2 to HCF PWB PF01-2 • Tray 6 Feed Out Sensor PF67-1 to HCF PWB PF01-3 • Tray 6 Feed Out Sensor PF67-3 to HCF PWB PF01-1 If OK, replace the Tray 6 Feed Out Sensor (PL 18.7) then the HCF PWB (PL 18.8). Check the HCF paper lift components and repair as required (PL 18.2, PL 18.3).