Code: 078-945
Description: TTM Tray 3 Lift RAP There is a problem with the TTM Tray 3 Lift.
Remedy: Enter Component Control [071-002 or 073-009 Tray 3 Feed/Lift Motor ON]. The Tray 3 Feed/ Lift Motor (PL 12.3) can be heard (the lifted paper plate drops when the tray is opened). Y↓N→Check the connections of P/J220B, P/J661B, P/J549. P/J220B, P/J661B, P/J549 are connected correctly. Y↓N→Connect P/J220B, P/J661B, P/J549. Remove the Tray 3 Feed/Lift Motor (PL 12.3) and the Tray 2 Feed/Lift Motor (PL 12.3). Replace the Tray 3 Feed/Lift Motor with the Tray 2 Feed/Lift Motor. Enter Component Control [071-002 or 073-009 Tray 3 Feed/Lift Motor ON]. The Tray 3 (2) Feed/Lift Motor (PL 12.3) can be heard (the lifted paper plate drops when the tray is opened). Y↓N→Return the Tray 2 Feed/Lift Motor to its original position. Check the wires between P/J220B and P/J549 for an open circuit or a short circuit. The circuit between J220B and J549 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Replace the Tray Module PWB (PL 13.8). Return the Tray 2 Feed/Lift Motor to its original position. Replace the Tray 3 Feed/Lift Motor (PL 12.3). Check the installation of the Tray 3 Level Sensor (PL 12.3) and the operation of the actuator. The Tray 3 Level Sensor is installed correctly and the actuator works. Y↓N→Reinstall the Tray 3 Level Sensor (PL 12.3). Enter Component Control [071-208 Tray 3 Level Sensor]. Manually actuate the Tray 3 Level Sensor (PL 12.3). The display changes. Y↓N→Check the connections of P/J101B, P/J661B and P/J549. P/J101B, P/J661B and P/ J549 are connected correctly. Y↓N→Connect P/J101B, P/J661B and P/J549. Check the wires between P/J101B and P/J549 for an open circuit or a short circuit. The circuit between J101B and J549 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Measure the voltage between the Tray Module PWB P/J549-7 (+) and P/J549-8 (-). The voltage is approx. +5VDC. Y↓N→Replace the Tray Module PWB (PL 13.8). Measure the voltage between the Tray Module PWB P/J549-9 (+) and GND (-). Activate the actuator of the Tray 3 Level Sensor (PL 12.3). The voltage changes. Y↓N→Replace the Tray 3 Level Sensor (PL 12.3). Replace the Tray Module PWB (PL 13.8). Check the TTM paper lift components and repair as required (PL 12.3, PL 13.8).