Code: 010-338
Description: Fuser On Time Failure RAP • After the Main Lamp turned On during warm up, the Control Thermistor did not detect READY temperature within the specified time. • After the Main Lamp turned On during standby, the Control Thermistor did not detect a specific temperature within the specified time. • After the Sub Lamp turned On during standby, the Control Thermistor did not detect a specific temperature within the specified time. • After the empty rotation started, the Control Thermistor did not detect the empty rotation finishing temperature within the specified time. • After the Main Lamp turned On during printing, the Control Thermistor did not detect a specific temperature within the specified time. • After the Sub Lamp turned On during printing, the Control Thermistor did not detect a specific temperature within the specified time.
Remedy: NOTE: When this fault occurs, NVM location 744-005 is set to 1, 2, or 3, depending on the fault. You must reset this location to 0 in order to clear the fault. Check for paper on the Fuser. The Fuser has no paper wrapped round it. Y↓N→Remove the paper. Check the installation of the Fuser Unit. The Fuser Unit is securely installed. Y↓N→Install the Fuser Unit securely. Remove the Fuser Unit. Check the conductivity of the contact points of the Thermostat. The contact points are connected. Y↓N→Replace the Fuser Unit (PL 7.1). Check the resistance of the Main Lamp between J621-6 and J621-7 for an open circuit or a short circuit (BSD 10.1). The resistance of the Main Lamp is 100 ohms or lower. Y↓N→Replace the Fuser Unit (PL 7.1). Check the resistance of the Sub Lamp between J621-2 and J621-7 for an open circuit or a short circuit (BSD 10.1). The resistance of the Sub Lamp is 100 ohms or lower. Y↓N→Replace the Fuser Unit (PL 7.1). Check the resistance of the Control (Center) Thermistor between J621-5 and J621-1 (BSD 10.1). There is no open circuit in the Center STS and the resistance is 3k ohms or higher. Y↓N→Replace the Fuser Unit (PL 7.1). Check the resistance of the Rear Thermistor between J621-7 and J621-3 (BSD 10.1). The resistance is 3k ohms or higher. Y↓N→Replace the Fuser Unit (PL 7.1). Check the wire between P/J411-B7 and J621-7 for an open circuit or a short circuit ( BSD 10.1). The wire between P/J411 and J621 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Check the wire between P/J414 and P530 for an open circuit or a short circuit (BSD 10.1). The wire between P/J414 and P530 conducts and if free of a short circuit. Y↓N→Repair the open circuit or short circuit. Replace the Fuser Unit (PL 7.1). If the problem persists, replace the AC Drive PWB (PL 18.2) If the problem persists, replace the MCU PWB (PL 18.2).