Description: Fuser Hot Not Ready Return Time Failure RAP Recovery time from High-temp Not Ready state becomes larger than the setting value (NVM).
Remedy: Check for paper on the Fuser. The Fuser has no paper wrapped round it. Y↓N→Remove the paper. Check the installation of the Fuser Unit. The Fuser Unit is securely installed. Y↓N→Install the Fuser Unit securely. Check the resistance of the Rear Thermistor between J621-7 and J621-3 ( BSD 10.1). The resistance is 3k ohms or higher. Y↓N→Replace the Fuser Unit (PL 7.1). Check the resistance of the Center Thermistor between J621-5 and J621-1 (BSD 10.1). The resistance is 3k ohms or higher. Y↓N→Replace the Fuser Unit (PL 7.1). Check the wire between P/J411 and J621 for an open circuit or a short circuit (BSD 10.1). The wire between P/J411 and J621 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Replace the Fuser Unit (PL 7.1). If the problem persists, replace the MCU PWB (PL 18.2).