Description: (Integrated Finisher) Entrance Sensor ON Jam RAP Finisher Entrance Sensor does not turn On within a specified time after receiving the Sheet Exit command (the sheet to be ejected has turned ON the IOT Exit Sensor 1).
Remedy: Check the specifications of paper. Paper is in spec. Y↓N→Replace the paper with new paper that is in spec. Check the condition of the paper. The paper is in normal condition without any problem that causes the paper to be bent or caught. Y↓N→Resolve any problem that causes the paper to be bent or caught. Check the transport path for a foreign object, deformed part, and paper dust. The transport path is in normal condition. Y↓N→Repair the deformed part(s) and remove the foreign object(s) and paper dust. Check that the Finisher is installed properly. The Finisher is properly installed and properly connected to the IOT. Y↓N→Reinstall the Finisher properly. Enter Component Control [012-140]. Actuate the Finisher Entrance Sensor. The display changes. Y↓N→Check the connections of P/J8709 and P/J8729. P/J8709 and P/J8729 are securely connected. Y↓N→Connect P/J8709 and P/J8729 securely. Check for an open or short circuit between P/J8709 and P/J8729. The wires between P/J8709 and P/J8729 are OK. Y↓N→Repair the open or short circuit. Measure the voltage between Finisher PWB P/J8709-6 (+) and GND (-). The voltage is approx. +5VDC. Y↓N→Go to Integrated Finisher Wirenets and check the +5VDC circuit. Measure the voltage between Finisher PWB P/J8709-5 (+) and GND (-). Actuate the Finisher Entrance Sensor. The voltage changes. Y↓N→Replace the Finisher Entrance Sensor (PL 22.5). Check the wires and connectors for an intermittent open or short circuit. If the problem continues, replace the Finisher PWB (PL 22.7). Check the wires and connectors for an intermittent open or short circuit. If the problem continues, replace the Finisher PWB (PL 22.7).