Code: 012-161
Description: Finisher Set Eject Jam RAP (LX) After the Eject Motor turned On, the Compiler Tray No Paper Sensor did not turn Off within the specified time.
Remedy: Enter Component Control [012-151], Compiler Tray No Paper Sensor. Select Start. Actuate the Compiler Tray No Paper Sensor. The display changes. Y↓N→Check the wire between J8880 pin 2 and P/J8994 pin 2 on the Finisher PWB for an open or short circuit, or a loose or damaged connector. The wire is OK. Y↓N→Repair/reconnect as required. Measure the voltage between P/J8994 pins 3 and 1 on the Finisher PWB. The voltage is approx. +5VDC. Y↓N→Replace the Finisher PWB (PL 23.16). Measure the voltage between P/J8994 pin 2 on the Finisher PWB and GND (BSD 12.19 - Office Finisher LX Tamping & Offset (2 of 2) Actuate the Compiler Tray No Paper Sensor. The voltage changes. Y↓N→Replace the Compiler Tray No Paper Sensor (PL 23.12). Replace the Finisher PWB (PL 23.16). Alternately execute Component Control [012-054 Eject Motor FORWARD LO] and Component Control [012-055 Eject Motor FORWARD HI]. The Eject Motor starts up. Y↓N→Check the wires between P/J8878 on the Eject Motor and P/J8983 on the Finisher PWB (BSD 12.22 - Office Finisher LX Eject Control (1 of 2)) for an open or short circuit, or a loose or damaged connector. The wires are OK. Y↓N→Repair/reconnect as required. Measure the resistance of the Eject Motor between each point of P/J8878-1/3/4/6. The resistance is approx. 20 Ohm. Y↓N→Replace the Eject Motor (PL 23.11). Replace the Eject Motor (PL 23.11). If the problem persists, replace the Finisher PWB (PL 23.16). Check the Exit Roller, Entrance Roller, Paddle Shaft and Eject Belt for wear, damage or contamination (PL 23.13). Check the Compiler Tray No Paper Sensor and Eject Motor circuits for an intermittent condition. If the problem continues, replace the Finisher PWB (PL 23.16).