Code: 012-223
Description: Front Tamper Home Sensor Off Failure RAP (LX) After the Front Tamper started moving away from the home position, the Front Tamper Home Sensor did not turn Off within the specified time.
Remedy: Manually operate the Tamper mechanism. The Tamper mechanism moves smoothly. Y↓N→Replace the parts that are interfering with operation. Execute Component Control [012-220], Front Tamper Home Sensor. Manually operate the Tamper mechanism to block and unblock the sensor. The display changes. Y↓N→Check the wire between J8881 pin 2 and P/J8994 pin 5 for an open or short circuit, or a loose or damaged connector. The wire is OK. Y↓N→Repair/reconnect as required. Measure the voltage between P/J8994, pins 6 and 4 on the Finisher PWB BSD 12.18 - Office Finisher LX Tamping & Offset (1 of 2). The voltage is approx. +5VDC. Y↓N→Replace the Finisher PWB (PL 23.16). Measure the voltage between P/J8994, pin 5 on the Finisher PWB and GND (BSD 12.18 - Office Finisher LX Tamping & Offset (1 of 2). Manually operate the Tamper mechanism to block and unblock the Front Tamper Home Sensor. The voltage changes. Y↓N→Replace the Front Tamper Home Sensor (PL 23.12). Replace the Finisher PWB (PL 23.16). Alternately execute Component Control [012-020], Front Tamper Motor Front and [012-023], Front Tamper Motor Rear. The Front Tamper Motor moves. Y↓N→There is +24 VDC from P/J8994 pin 19 on the Finisher PWB to GND Y↓N→There is +24 VDC from J8982 pin 4 on the Finisher PWB to GND Y↓N→Go to BSD 12.12 - Office Finisher LX Interlock Switching: J8982 and check the +24V circuit feeding pin 4. Repair/reconnect as required. Replace the Finisher PWB (PL 23.16). Check the wires between P/J8994, pins 18 ~ 22 on the Finisher PWB, and the Front Tamper Motor P/J8884 for an open or short circuit, or a loose or damaged connector. The wires are OK. Y↓N→Repair/reconnect as required. Replace the Front Tamper Motor (PL 23.12). If the problem persists, replace the Finisher PWB (PL 23.16). Replace the Finisher PWB (PL 23.16).