Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 012-243 — Xerox WorkCentre 5325

Code: 012-243

Description: Booklet Folder Home Sensor On Fail RAP (LX) Folder Home Sensor is not turned on after the lapse of 500ms from Motor ON while Folder Knife is returning to Home.
Remedy: Enter Component Control [013-022], Folder Knife Motor FWD and [013-023], Folder Knife Motor REV alternately. Select Start. The Fold Knife Motor energizes. Y↓N→Select Stop. Refer to (BSD 12.17 - Office Finisher LX Folding. Check continuity between the Booklet Folder Knife Motor ( P/J8905) and the Finisher PWB ( P8985), and between the Booklet PWB ( P/J8994) and the Finisher PWB ( P8985). The continuity check is OK. Y↓N→Repair the open circuit or short circuit. Replace the Booklet Folder Knife Motor (PL 23.15). If the problem continues, replace the Booklet PWB (PL 23.21). Select Stop. Enter [13-101], Folder Home Sensor. Select Start. Block/unblock the Folder Home Sensor. The display changed. Y↓N→Check the wire between J8904 pin 2 and P/J8990 pin 2 on the FInisher PWB for an open or short circuit, or a loose or damaged connector. The wire is OK. Y↓N→Repair/reconnect as required. Measure the voltage between P/J8990, pins 3 and 1 on the Finisher PWB (BSD 12.17 - Office Finisher LX Folding The voltage is approx. +5VDC. Y↓N→Replace the Finisher PWB (PL 23.16). Measure the voltage between P/J8990, pin 2 on the Finisher PWB and GND BSD 12.17 - Office Finisher LX Folding. Block/unblock the Folder Home Sensor. The voltage changes. Y↓N→Replace the Folder Home Sensor (PL 23.15). Replace the Finisher PWB (PL 23.16). If the problem continues, replace the Finisher PWB (PL 23.16).

← Xem tất cả mã lỗi Xerox WorkCentre 5325

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie