Code: 012-265
Description: Booklet Folder Home Sensor OFF Fail RAP (LX) When the Booklet Home moves from Home position, the Folder Home Sensor did not turn OFF within the specified time.
Remedy: Enter Component Control [013-022], Folder Knife Motor FWD and [013-023], Folder Knife Motor REV alternately. Select Start. The Fold Knife Motor energizes. Y↓N→Select Stop. Refer to BSD 12.17 - Office Finisher LX Folding Check continuity between the Folder Knife Motor ( P/J8905) and the Finisher PWB ( P8985), and between the Booklet PWB ( P/J8994) and the Finisher PWB ( P8985). The continuity check is OK. Y↓N→Repair the open circuit or short circuit. Replace the Folder Knife Motor (PL 23.15). If the problem continues, replace the Booklet PWB (PL 23.21). Select Stop. Enter [13-101], Folder Home Sensor. Select Start. Block/unblock the Folder Home Sensor. The display changed. Y↓N→Check the wire between J8904 pin 2 and P/J8990 pin 2 on the FInisher PWB for an open or short circuit, or a loose or damaged connector. The wire is OK. Y↓N→Repair/reconnect as required. Measure the voltage between P/J8990, pins 3 and 1 on the Finisher PWB BSD 12.17 - Office Finisher LX Folding The voltage is approx. +5VDC. Y↓N→Replace the Finisher PWB (PL 23.16). Measure the voltage between P/J8990, pin 2 on the Finisher PWB and GND (BSD 12.17 - Office Finisher LX Folding.Block/unblock the Folder Home Sensor. The voltage changes. Y↓N→Replace the Folder Home Sensor (PL 23.15). Replace the Finisher PWB (PL 23.16). If the problem continues, replace the Finisher PWB (PL 23.16).