Description: Paper at Finisher Entrance Sensor RAP (LX) Control logic reports paper at the Finisher Entrance Sensor.
Remedy: Enter Component Control [012-100], Finisher Entrance Sensor. Select Start. Actuate the Finisher Entrance Sensor. The display changes. Y↓N→Check the wire between J8868 pin 2 and P/J8988 pin 2 for an open or short circuit, or a loose or damaged connector. The wire is OK. Y↓N→Repair/reconnect as required. Measure the voltage between P/J8988 pins 3 and 1 on the Finisher PWB (BSD 12.16 - Office Finisher LX Transportation). The voltage is approx. +5VDC. Y↓N→Replace the Finisher PWB (PL 23.16). Measure the voltage between P/J8988 pin 2 on the Finisher PWB and GND (BSD 12.16 - Office Finisher LX Transportation). Actuate the Finisher Entrance Sensor. The voltage changes. Y↓N→Replace the Finisher Entrance Sensor (PL 23.14). Replace the Finisher PWB (PL 23.16). Replace the Finisher PWB (PL 23.16).