Description: Tray 3 No Paper RAP Tray 3 is out of paper.
Remedy: Check the installation of the Tray 3 No Paper Sensor (PL 10.4) and the operation of the actuator. The Sensor is installed correctly and the actuator works. Y↓N→Reinstall the Sensor. Execute Component Control [073-101], Tray 3 No Paper Sensor. Manually activate the Tray 3 No Paper Sensor (PL 11.8). The display changes. Y↓N→Go to BSD 7.7 - Tray 3 Paper Stacking (TTM) Troubleshoot the circuit of the Tray 3 Tray Empty Sensor. Refer to the OF 99-2, Transmissive Sensor RAP. Go to the 073-210 RAP to check the Tray 3 Feed LIft Motor. • Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware module, EEPROM) • Check the sw version of the controller sw - update if required (GP 16)