Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 073-101 — Xerox WorkCentre 5325

Code: 073-101

Description: Tray 3 Misfeed RAP The Tray 3 Feed Out Sensor does not turn ON within the specified time after the Feed from Tray 3 has started.
Remedy: Remove Tray 3. Turn the power ON and enter the Diag mode. Turn ON Component Control [073-001] (Tray 3 Feed/Lift Motor). Does the Tray 3 Feed/Lift Motor rotate? Y↓N→Go to the +24VDC-2 IOT wirenets. Is the voltage between the Tray Module PWB P/J 541-8 (+) and the GND (-) +24VDC? Y↓N→Go to +24VDC Power RAP. Turn the power OFF, then measure the Tray 3 Feed/Lift Motor wire wound resistance. Check the resistance of the following. • Between the Tray Module PWB P/J555 -1 and P/J555-2 • Between the Tray Module PWB P/J555-3 and P/J555-4 Is the resistance approx. 4Ohm for each? (When the temperature is 25 °C) Y↓N→Check the connection between the Tray Module PWB P/J555 and the Tray 3 Feed/ Lift Motor P/J222 for open circuit, short circuit, and poor contact. If there are no problems, replace the Tray 3 Feed/Lift Motor (PL 11.9). Measure the resistance between the Tray Module PWB P/J555-1/2/3/4 and the Frame. Is the resistance infinite for all? Y↓N→Check the wires of the pins with non-infinite resistance for peeled-off coatings and short circuits due to pinching. Replace the following parts in sequence: • Tray Module PWB (PL 11.13) • MCU PWB (PL 18.2) • Press the Stop button. Turn ON Component Control [077-033] (TM Takeaway Motor).

← Xem tất cả mã lỗi Xerox WorkCentre 5325

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie