Code: 077-129
Description: Registration Sensor On Jam (Duplex Wait) RAP The Registration Sensor does not turn ON within the specified time after the Registration Clutch On after the Feed has started in Duplex Direct mode.
Remedy: Check the following: • A paper transportation failure due to a foreign substance/burr on the paper path • Each Duplex Roll and Pinch Roll for contamination, wear, and revolution failure • Each Duplex Roll Drive Gear for wear and damage • Use of paper out of spec • The Registration Sensor for contamination, improper installation, and Actuator operation failure
Check the following: • The Registration Sensor for failure: Component Control [077-104] (PL 15.1) • The connection between the Registration Sensor P/J121 and the MCU PWB P/J415 for open circuit, short circuit, and poor contact • The Registration Clutch for failure: Component Control [077-002] (PL 15.1) • The Main Drive Motor for revolution failure: Component Control [042-003] CW (PL 3.2) • The Takeaway Clutch for failure: Component Control [077-001] (PL 15.1) • The Registration Transport Assy (PL 15.1) for installation failure • The Duplex Motor for failure: Component Control [077-070] (PL 14.4) Reload the machine software (GP 16). If no problems are found, replace the MCU PWB (PL 18.2).
Check the following: • The Registration Sensor for failure: Component Control [077-104] (PL 15.1) • The connection between the Registration Sensor P/J121 and the MCU PWB P/J415 for open circuit, short circuit, and poor contact • The Registration Clutch for failure: Component Control [077-002] (PL 15.1) • The Main Drive Motor for revolution failure: Component Control [042-003] CW (PL 3.2) • The Takeaway Clutch for failure: Component Control [077-001] (PL 15.1) • The Registration Transport Assy (PL 15.1) for installation failure • The Duplex Motor for failure: Component Control [077-070] (PL 14.4) Reload the machine software (GP 16). If no problems are found, replace the MCU PWB (PL 18.2).