Code: 005-123
Description: DADF Simplex/Side 1 Registration Sensor On Jam RAP After Pre Registration operation started (DADF Feed Motor On (CCW)), the DADF Registration Sensor did not turn ON within the specified time.
Remedy: Open the Top Cover and remove the Invert Chute. Enter the Diag Mode, turn ON Component Control [005-110]. Turn ON the DADF Registration Sensor using a sheet of paper, etc. Does the display change to "H" (opposite to the voltage level)? Y↓N→Remove the DADF Rear Cover. Is the voltage between the DADF PWB P/J757-14 (+) and the GND (-) +5VDC? Y↓N→Replace the DADF PWB (PL 51.2). The voltage between the DADF Registration Sensor P/J775-2 (+) and the GND (-) +5VDC? Y↓N→Check the connection between the DADF Registration Sensor P/J775-2 and the DADF PWB P/J757-14 for an open circuit and poor contact. The voltage between the DADF Registration Sensor P/J775-1 (+) and P/J775-3 (-) +5VDC? Y↓N→Check the wires between the DADF PWB P/J757-15 and the DADF Registration Sensor P/J775-1, as well as between the DADF PWB P/J757-13 and the DADF Registration Sensor P/J775-3 for open circuits and poor contacts. Replace the DADF Registration Sensor (PL 51.17). Press the Stop button. Turn ON Component Control [005-008] (DADF Feed Motor). Does the DADF Feed Motor operate? Y↓N→The voltage between the DADF Feed Motor P/J776-5/2 (+) and the GND (-) +24VDC? Y↓N→The voltage between the DADF PWB P/J754-B1/B2 (+) and the GND (-) +24VDC? Y↓N→The voltage between the DADF PWB P/J753-2 (+) and the GND (-) +24VDC? Y↓N→Refer to BSD 5.1 - Document Setting and check the +24VDC circuit to the DADF PWB P/J753-2. Replace the DADF PWB (PL 51.2). Check the wires between the DADF PWB P/J754-B1 and the DADF Feed Motor P/ J776-5, as well as between the DADF PWB P/J754-B2 and the DADF Feed Motor P/J776-2 for an open circuit and poor contact. Turn OFF the power and disconnect P/J754 from the DADF PWB. Measure the wire wound resistance of the Motor. • Between P/J754 pin-B1 and P/J754 pin-B5/B6 • Between P/J754 pin-B2 and P/J754 pin-B3/B4 The resistance approximately 1Ohm for each? Y↓N→Replace the DADF Feed Motor (PL 51.5). Replace the DADF PWB (PL 51.2). Check the following: • The document path for foreign substances. • The Transportation Roll for contamination, wear or revolution failure.