Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 010-379 — Xerox WorkCentre 5330

Code: 010-379

Description: Fuser Hot Not Ready Return Time Failure RAP Recovery time from High-temp Not Ready state becomes larger than the setting value (NVM).
Remedy: Check for paper on the Fuser. The Fuser has no paper wrapped round it. Y↓N→Remove the paper. Check the installation of the Fuser Unit. The Fuser Unit is securely installed. Y↓N→Install the Fuser Unit securely. Check the resistance of the Rear Thermistor between J621-7 and J621-3 ( BSD 10.1). The resistance is 3k ohms or higher. Y↓N→Replace the Fuser Unit (PL 7.1). Check the resistance of the Center Thermistor between J621-5 and J621-1 (BSD 10.1). The resistance is 3k ohms or higher. Y↓N→Replace the Fuser Unit (PL 7.1). Check the wire between P/J411 and J621 for an open circuit or a short circuit (BSD 10.1). The wire between P/J411 and J621 is conducting without an open circuit or a short circuit. Y↓N→Repair the open circuit or short circuit. Replace the Fuser Unit (PL 7.1). If the problem persists, replace the MCU PWB (PL 18.2).

← Xem tất cả mã lỗi Xerox WorkCentre 5330

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie