Code: 012-132
Description: Finisher Entrance Sensor On Jam RAP (LX) After the Fuser Exit Sensor turned On, the Finisher Entrance Sensor did not turn On within the specified time.
Remedy: Execute Component Control [012-100], Finisher Entrance Sensor. Actuate the Finisher Entrance Sensor (PL 23.14). The display changes. Y↓N→Check the wire between J8868 pin 2 and P/J8988 pin 2 for an open or short circuit, or a loose or damaged connector. The wire is OK. Y↓N→Repair/reconnect as required. Measure the voltage between P/J8988, pins 3 and 1 on the Finisher PWB. The voltage is approx. P/J8988 +5VDC. Y↓N→Replace the Finisher PWB (PL 23.16). Measure the voltage between P/J8988, pin 2 on the Finisher PWB and GND. Actuate the Finisher Entrance Sensor. The voltage changes. Y↓N→Replace the Finisher Entrance Sensor (PL 23.14). Replace the Finisher PWB (PL 23.16). Execute Component Control [012-038], Transport Motor. The Transport Motor rotates. Y↓N→Check the wires between P/J8879 on the Transport Motor and P/J8983 on the Finisher PWB for an open or short circuit, or a loose or damaged connector. The wires are OK. Y↓N→Repair/reconnect as required. Measure the resistance of the Transport Motor between each pin P/J8879-1/2/5/6. The resistance is approx. 20 Ohm. Y↓N→Replace the Transport Motor (PL 23.13). Replace the Finisher PWB (PL 23.16). If the problem persists, replace the Transport Motor (PL 23.13). Check the Entrance Roller, Paddle Shaft and Eject Belt for wear, damage or contamination (PL 23.13). Check the Finisher Entrance Sensor and Transport Motor circuits for an intermittent condition. If the problem continues, replace the Finisher PWB (PL 23.16).