Code: 012-224
Description: Rear Tamper Home Sensor Off Failure RAP (LX) After the Rear Tamper started moving away from the home position, the Rear Tamper Home Sensor did not turn Off within the specified time.
Remedy: Manually operate the Tamper mechanism. The Tamper mechanism moves smoothly. Y↓N→Replace the parts that are interfering with operation. Execute Component Control [012-221], Rear Tamper Home Sensor. Manually operate the Tamper mechanism to block and unblock the sensor. The display changes. Y↓N→Check the wire between J8882 pin 2 and P/J8994 pin 8 for an open or short circuit, or a loose or damaged connector. The wire is OK. Y↓N→Repair/reconnect as required. Measure the voltage between P/J8994, pins 9 and 7 on the Finisher PWB. The voltage is approx. +5VDC. Y↓N→Replace the Finisher PWB (PL 23.16). Measure the voltage between P/J8994, pin 8 on the Finisher PWB and GND. Manually operate the Tamper mechanism to block and unblock the Rear Tamper Home Sensor. The voltage changes. Y↓N→Replace the Rear Tamper Home Sensor (PL 23.12). Replace the Finisher PWB (PL 23.16). Alternately execute Component Control [012-026], Rear Tamper Motor Front and [012-029], Rear Tamper Motor Rear. The Rear Tamper Motor moves. Y↓N→There is +24 VDC from P/J8994 pin 19 on the Finisher PWB to GND Y↓N→There is +24 VDC from J8982 pin 4 on the Finisher PWB to GND Y↓N→Go to BSD 12.12 - Office Finisher LX Interlock Switching and check the +24V circuit feeding pin 4. Repair/reconnect as required. Replace the Finisher PWB (PL 23.16). Check the wires between P/J8994, pins 13 ~ 17 on the Finisher PWB, and the Rear Tamper Motor P/J8883 for an open or short circuit, or a loose or damaged connector. The wires are OK. Y↓N→Repair/reconnect as required. Replace the Rear Tamper Motor (PL 23.12). If the problem persists, replace the Finisher PWB (PL 23.16). Replace the Finisher PWB (PL 23.16).