Code: 012-263
Description: Rear Tamper Failure RAP (LX) After the Rear Tamper started moving to the home position, the Rear Tamper Home Sensor did not turn On within 800ms.
Remedy: Manually operate the Tamper mechanism. The Tamper mechanism moves smoothly. Y↓N→Replace the parts that are interfering with operation. Execute Component Control [012-221], Rear Tamper Home Sensor. Manually operate the Tamper mechanism to block and unblock the sensor. The display changes. Y↓N→Check the wire between J8882 pin 2 and P/J8994 pin 8 for an open or short circuit, or a loose or damaged connector. The wire is OK. Y↓N→Repair/reconnect as required. Measure the voltage between P/J8994, pins 9 and 7 on the Finisher PWB. The voltage is approx. +5VDC. Y↓N→Replace the Finisher PWB (PL 23.16). Measure the voltage between P/J8994, pin 8 on the Finisher PWB and GND BSD 12.19 - Office Finisher LX Tamping & Offset (2 of 2). Manually operate the Tamper mechanism to block and unblock the Rear Tamper Home Sensor. The voltage changes. Y↓N→Replace the Rear Tamper Home Sensor (PL 23.12). Replace the Finisher PWB (PL 23.16). Alternately execute Component Control [012-026], Rear Tamper Motor Front and [012-029], Rear Tamper Motor Rear. The Rear Tamper Motor moves. Y↓N→There is +24 VDC from P/J8994 pin 14 on the Finisher PWB to GND Y↓N→There is +24 VDC from J8982 pin 4 on the Finisher PWB to GND Y↓N→Go to BSD 12.12 - Office Finisher LX Interlock Switching and check the +24V circuit feeding pin 4. Repair/reconnect as required. Replace the Finisher PWB (PL 23.16). Check the wires between P/J8994, pins 13 ~ 17 on the Finisher PWB, and the Rear Tamper Motor P/J8883 for an open or short circuit, or a loose or damaged connector. The wires are OK. Y↓N→Repair/reconnect as required. Replace the Rear Tamper Motor (PL 23.12). If the problem persists, replace the Finisher PWB (PL 23.16). Replace the Finisher PWB (PL 23.16).