Code: 012-268
Description: Booklet Rear Stapler Fail RAP (LX) The Booklet Rear Staple Home Switch is not ON (does not return to home position) within the specified time after the Booklet Rear Staple Motor starts to reverse.
Remedy: Enter Component Control [12-026], Staple Motor FWD. and then [12-027], Staple Motor REV. The Front Booklet Stapler cycles normally. Y↓N→There is +24 VDC from P/J8993 pin 5 on the Booklet PWB to GND. Y↓N→Check the circuit from the Booklet PWB to the Booklet Stapler Cover Switch (BSD 12.13 - Office Finisher LX Booklet Interlock Switching. Repair/replace as required (PL 23.21). Switch off the power. Check the wires between P/J8995 on the Booklet PWB and P/ J8995 on the Rear Booklet Stapler BSD 12.27 - Office Finisher Booklet Staple Control (2 of 2 - Rear) for a loose or damaged connector, or an open or short circuit. If the wires are OK, replace the Rear Booklet Stapler Assembly (PL 23.20). If the problem remains, replace the Booklet PWB (PL 23.21). Switch off the power. Check the wire between P/J8995, pin 12 on the Booklet PWB and P/ J8995 pin 3 on the Rear Booklet Stapler BSD 12.27 - Office Finisher Booklet Staple Control (2 of 2 - Rear) for a loose or damaged connector, or an open or short circuit. If the wires are OK, replace the Rear Booklet Stapler Assembly (PL 23.20). If the problem remains, replace the Booklet PWB (PL 23.21).